В общем вот какими параметрами описывается панель и значения которые стоят.
#define _OUTPUT_BUS _PANEL_LVDS
#define _DISP_BIT _DISP_18_BIT
#define _DISPLAY_PORT _DISP_SINGLE_PORT
#define _DISP_WID 1024 // Display Horizontal Width
#define _DISP_LEN 600 // Display Vertical Height
#define _DH_ACT_STA_POS 48 // Display Horizontal Start Position
#define _DH_ACT_END_POS (_DISP_WID + _DH_ACT_STA_POS)
#define _DV_ACT_STA_POS 3// 12//16
#define _DV_ACT_END_POS (_DISP_LEN + _DV_ACT_STA_POS)
#define _LVDS_MAP _LVDS_MAP2
#define _STD_DH_TOTAL 1160 // Display Horizontal Total Clock Number in One Display Line
#define _STD_DV_TOTAL 612 // Display Vertical Total Line Number in One Frame
#define _STD_PIXCEL_CLOCK 45 // Typical Pixel Clock in MHz
#define _HSYNC_WIDTH 32 // Display H Sync Width
#define _VSYNC_HEIGHT 6 // Display V Sync Height
#define _DPLL_N_CODE 8//16
#define _LAST_LINE_FINETUNE _LAST_LINE_METHOD_NONE
#define _AUTOCALC_PIXCLK (_DISABLE << 2)
#define _DHS_MASK 0//(1 << 7)
#define _DVS_INVERT (_DISABLE << 2)
#define _DHS_INVERT (_DISABLE << 1)
#define _DEN_INVERT (_DISABLE)
#define _DISPLAY_INVERT (_DVS_INVERT | _DHS_INVERT | _DEN_INVERT)
#define _DISPLAY_CTRL (_DHS_MASK | _DISPLAY_INVERT)
#define _H_FREQ_MAX 930 // H Sync Max Freq Unit in 0.1 kHZ
#define _H_FREQ_MIN 200 // H Sync Min Freq Unit in 0.1 kHZ
#define _V_FREQ_MAX 650 // V Sync Max Freq Unit in 0.1 HZ
#define _V_FREQ_MIN 550 // V Sync Min Freq Unit in 0.1 HZ
#define LVDS_CTRL_LEVEL 4 //0~7
|